Operations While Scanning Documents; If The Memory Becomes Full - Develop FK-506 User Manual

Faxing
3.5

Operations while scanning documents

If the memory becomes full

If the memory becomes full while documents are being scanned when
queuing a transmission (specifying a fax transmission while another fax
transmission job is being performed) or for a timer transmission, a message
appears, allowing you to select whether to send the scanned pages or cancel
the transmission.
Note
If the memory becomes full (0% appears for the amount of memory
available), all pages that have been scanned are erased.
If the transmission is to be canceled
The data for the scanned pages are erased. Wait until all fax transmission or
reception operations are finished, check the amount of memory that is
available, and then perform the fax transmission again.
If the scanned pages are to be sent
If the document was scanned from the original glass, send the scanned
document pages, and then finish the operation. Check the amount of
memory that is available, and then perform the fax transmission again.
If the document was scanned from the document feeder or reverse
automatic document feeder, send the scanned document pages, and then
scan and send the document pages remaining in the document feed tray.
FK-506
MEM.FULL/TX CANCEL
YES
NO
3
3-31