Table of Contents
Advertisement
Utility mode/Fax mode parameters
–
If settings are not to be specified for F-code transmission, the
communication speed or the transmission time, press the [OK] key.
The settings are registered, continue with step 8.
–
To specify settings for F-code transmission, the communication
speed or the transmission time, press the [,], and then continue
with the next step.
–
For details on F-codes (SUB address and password), refer to
"Using F-codes" on page 4-3.
–
If an e-mail address is entered for the destination and the [,] key is
pressed, the BASIC/ADVANCED settings can be specified. For
details on the BASIC/ADVANCED settings, refer to "Selecting
BASIC/ADVANCED settings" on page 5-10.
6
Press the [+] or [,] key until the parameter to be set is selected, and
then press the [OK] key.
–
If "SUB, SID SETTING" was selected: Type in the SUB address and
password. A maximum of 20 digits can be entered for the SUB
address and password.
FK-506
ONE-TOUCH DIAL 0
SUB,SID SETTING
MODEM SPEED
BATCH TIME
SUB
5555
SID
000_
6
6-23
Advertisement
Table of Contents
