Scanning A Long Original ([Long Original]); Specifying The Original Loading Direction ([Original Direction]); Specifying The Original Binding Position ([Binding Position]); Scanning While Removing Dust From The Slit Glass ([Despeckle]) - Develop ineo+ 224 Instructions For Use Manual

1

Scanning a long original ([Long Original])

Load the long original that cannot be placed on the Original Glass and larger in the feeding direction than
the full standard size (A3 or 11 x 17) on ADF. There is no need to enter the original size in advance: the ADF
will detect the size automatically.
For details, refer to page 5-16.

Specifying the original loading direction ([Original Direction])

When scanning a 2-sided original etc., you can specify the direction in which the original is loaded so that
the vertical direction is set correctly.
For details, refer to page 5-16.

Specifying the original binding position ([Binding Position])

When scanning a 2-sided original, specify the original binding position in [Binding Position] to prevent the
binding positions from being reversed between the front and rear faces.
For details, refer to page 5-16.

Scanning while removing dust from the slit glass ([Despeckle])

When scanning an original in ADF, scanning of the original(s) and removal of dust from the Slit Scan Glass
are performed alternately, so that the original is always scanned using clean Slit Scan Glass.
It takes longer to finish scanning, compared to the normal operation.
For details, refer to page 5-16.
1-22
Option settings for fax transmission
ineo+ 224/284/364/454/554
1.4