When Faxing Is Not Performed Correctly; Faxes Cannot Be Sent - Develop FK-506 User Manual

7
7.2

When faxing is not performed correctly

Faxes cannot be sent

Symptom
The document cannot be
scanned.
The document was
scanned at an angle.
The fax received by the
recipient is not clear.
The fax received by the
recipient is blank.
Faxes cannot be sent au-
tomatically.
7-4
Possible cause
Is the document too thick?
Is the document tool thin or too
small?
Is the original glass dirty?
Were the document guides cor-
rectly adjusted to the width of
the document?
Is the document incorrectly po-
sitioned?
Is the original glass dirty?
Is the text in the document too
faint?
Is there a problem with the tele-
phone connection or with the re-
cipient's fax machine?
The document was sent with the
front side facing down (when us-
ing the document feeder).
Was the fax number incorrect?
Is a number specifically for tele-
phone calls being dialed?
Is there a problem with the re-
cipient's fax machine (it is out of
paper, it is not set to receive fax-
es automatically, it is turned off,
etc.)?
Troubleshooting
Remedy
Position the document on the
original glass to send it. (See
p. 3-9.)
Position the document on the
original glass to send it. (See
p. 3-9.)
Wipe the original glass with a
soft, dry cloth.
Adjust the document guides for
the size of the document. (See
p. 3-6.)
Position the document correct-
ly. (See p. 3-6.)
Wipe the original glass with a
soft, dry cloth.
Adjust the scanning density.
(See p. 6-69.)
Check that this machine can
make clean copies. If it can, try
sending the fax again.
Load the document with the
front side facing up, and then try
sending the fax again. (See
p. 3-6.)
Check the fax number.
Check the fax number.
Have the recipient check their
fax machine.
FK-506