Camera Registration; Device Scan; Advanced Setup: Video In Ip Setup - Eneo PNR-5332/3TB Quick Installation Manual

Camera Registration

Once Network Setup Wizard is complete, click the Scan but-
ton to scan for network cameras connected to NVR. You can
register analog and/or network IP cameras, up to 32 cameras
(User determines exact combination with a maximum of 16
analog inputs).

Device Scan

Click the "Scan" button and the Device Scan screen comes up.
Some functions may not be supported for the third party
cameras depending on their protocol and model.
● Protocol: Select the protocol used by the camera (for video
encoder) you wish to search for.
• ONVIF Protocol: select this protocol to register IP
cameras.
• iNEX Protocol: select this protocol to register PLS
encoders or analog cameras. Scanning with this setting
will automatically display 16 analog channels, corre-
sponding to the 16 video inputs on the rear panel.
8
Even if the network device uses a protocol sup-
ported by the NVR, the device itself may not be
visible for scanning and registration by the NVR.
For more information about supported network
devices and models, contact your retailer.
● Mode: Select the scan mode.
1 Mac Address: Displays the last 6 digits of the camera's
MAC address.
2 Address: Indicates the camera's searched IP address.
3 Model: Indicates the network camera's model or "analog"
if they are the analog cameras.
4 Name: Indicates the camera's name.
5 Status: Identifies the camera's registration status "regis-
tered" or "not registered. "

Advanced Setup: Video In IP Setup

If the camera is networked but not scanned, use this setup.
This setup allows you to change the network setting of the
NVR's VIDEO IN port which is camera's network environ-
ment. Check the camera's network setting first before you use
this setup.
Make sure that this setting does not conflict with the
WAN setting. For more information on the WAN set-
ting, refer to the operation manual.
1
Select Scan to commence scanning.
Only cameras that are connected to the NVR via
VIDEO IN ports can be scanned and registered.
2
Select a camera from the scan list and then select Add
Camera. The device login window will appear.
3
Enter a User ID and a Password for the selected camera.
- Apply to All Devices:
user and password to all selected devices if you selected
more than one device and the selected devices have the
same user ID and password.
Selects to apply the same