3: Basic Operation; Safety Warnings And Guidelines; Labels And Marking; General Precautions - Christie CP2000-ZX Setup Manual

3 Basic Operation
This projector is designed with safe and reliable operation in mind. However safe operation is not
assured by design alone; installers, service technicians, trained operators and all other users must
maintain a safe operating environment at all times. Read through this section in its entirety and
understand all warnings and precautions before attempting to operate the projector. NOTE: These
illustrations provided are to enhance the understanding of the written material and may not
represent your exact projector model. This section contains:
3.1

Safety Warnings and Guidelines

3.1.1 Labels and Marking

Observe and follow any warnings and instructions marked on the projector.
The exclamation point within the equilateral triangle indicates related operating/maintenance
instructions in the documentation accompanying the projector.
The lightning flash and arrowhead symbol within the equilateral triangle indicates non-insulated
"dangerous voltage" within the projector's enclosure that may be of sufficient magnitude to constitute
a risk of electric shock.

3.1.2 General Precautions

Be aware of the following general precautions in all CP2000-ZX installations:
Warnings! 1) Never look directly into the projector lens or at the lamp. The extremely high
brightness can cause permanent eye damage. 2) For protection from ultraviolet radiation,
keep all projector housings intact during operation. Protective safety clothing and safety
goggles are recommended when servicing.
NOTES: 1) The American Conference of Governmental Industrial Hygienists (ACGIH) recommends
occupational UV exposure for an 8-hour day to be less than 0.1 microwatts per square centimeters of
effective UV radiation. An evaluation of your workplace is advised to assure employees are not
exposed to cumulative radiation levels exceeding the government guidelines for your area. 2) Be
aware that some medications are known to increase one's sensitivity to UV radiation.
Warnings! 1) FIRE HAZARD. Keep hands, clothes, and all combustible material away
from the concentrated light beam of the lamp. 2) Position all cables where they cannot
contact hot surfaces or be pulled or tripped over.
This projector must be operated in an environment that meets the operating range specification. Refer
to Section 6: Specifications in the CP2000-ZX User Manual (020-100006-xx).
CP2000-ZX Setup Guide
020-100098-04 Rev. 1 (06-2009)
3-1