3: Basic Operation; Safety Warnings And Guidelines; General Precautions; Ac/Power Precautions - Christie CP2000-XB Setup Manual

3 Basic Operation
NOTE: The illustrations provided are to enhance the understanding of the written material. They are
graphical representations only and may not represent your exact projector model.
3.1

Safety Warnings and Guidelines

This projector is designed for safe and reliable operation. However safe operation is not assured by
design alone; installers, service technicians, trained operators and all other users must maintain a safe
environment at all times. Please read through and understand all warnings and precautions before
attempting to operate the projector.

3.1.1 General Precautions

Be aware of the following general precautions in all installations:
lamp. The extremely high brightness can cause permanent eye damage.
2) For protection from ultraviolet radiation, keep all projector housings
intact during operation. Protective clothing and safety goggles are rec-
ommended.
material at least 1m away from the concentrated light beam of the lamp. 2)
Position all cables where they cannot contact hot surfaces or be pulled or tripped
over.
NOTES: 1) The American Conference of Governmental Industrial Hygienists (ACGIH) recommends
occupational UV exposure for an 8-hour day to be less than 0.1 microwatts per square centimeters of
effective UV radiation. An evaluation of your workplace is advised to assure employees are not
exposed to cumulative radiation levels exceeding the government guidelines for your area. 2) Be
aware that some medications are known to increase one's sensitivity to UV radiation.
This projector must be installed on the floor only, and operated in an environment which meets the
operating range specifications. Refer to the CP2000-XB User Manual (020-100163-xx) for details.

3.1.2 AC/Power Precautions

voltage range
Do not allow anything to rest on the power cords. Place the projector in a location where the cords
cannot be abused by persons walking on them or objects rolling over them. Never operate the projector
if a power cable appears damaged in any way.
Do not overload power outlets and extension cords as this can result in fire or shock hazards.
CP2000-XB Setup Guide
020-100250-02 Rev. 1 (06-2009)
1) Never look directly into the projector lens or at the
1) FIRE HAZARD. Keep hands, clothes, and all combustible
Do not attempt operation if the AC supply is not within the specified
3-1