Display; Calibration - AMX Modero G4 Instruction Manual

Settings Pages

Display

The Display page (FIG. 9) controls the basic functions of the touch panel display, including the panel brightness.
FIG. 9
Display page
Display Page
Brightness:
Auto Dim:
Inactivity:
Display Timeout:

Calibration:

Calibration
In certain circumstances, it may be necessary to calibrate the touch panel's touch screen, in order to guarantee accurate
button selection. The Calibration page (FIG. 13) offers two options: the opportunity to calibrate the touch panel, and the
opportunity to ensure that a previous calibration is still accurate.
FIG. 10 Calibration page
To calibrate the touch panel:
1.
From the Settings page, select Display.
2.
From the Display page, select Calibration.
3.
To calibrate the touch panel, select Calibrate to open the Calibration page (FIG. 11).
8
Sets the display brightness and contrast levels of the panel.
• Move the slidebar to the left or right to adjust the brightness level.
Press this button to enable automatic dimming of the panel display if the Display Timeout
setting is enabled.
Indicates the length of time that the panel can remain idle before automatically flipping to a
pre-selected page.
• Press the Up/Down buttons to increase/decrease the Inactivity Page Flip Timeout setting.
Range = 1, 2, 5, 10, 15, 30 minutes, 1, 2, 3, 4 hours.
• Set the timeout value to Off to disable Inactivity Page mode.
Note: The touch panel page used for the Inactivity page flip is named within a small Inactivity
Page field below the buttons. The default reading is "MAIN".
Indicates the length of time that the panel can remain idle before the display automatically
powers down.
• Press the Up/Down buttons to increase/decrease the Display Timeout setting.
Range = 1, 2, 5, 10, 15, 30 minutes, 1, 2, 3, 4 hours.
• Set the timeout value to Off to disable Display Timeout mode.
Select this to open the Calibration page (page 9).
Modero G4 Touch Panels - Configuration and Programming