Sensor Settings - AMX Modero G4 Instruction Manual

G4 WebControl Page
G4 WebControl:
Timeout:
Name:
Password:
Port:
Maximum Connections: Displays the maximum number of users that can be simultaneously connected to this panel
Current Connections:
Modero XS Series G4 touch panels accelerate graphics rendering through hardware,
not software. When accessing the panel via VNC, a separate software graphics
engine is used, which may slow down graphics and panel responsiveness. In addition
to slowing down graphics and panel responsiveness, any video and animated
transitions will not be visible over VNC.

Sensor Settings

The Sensor Settings page (FIG. 43) allows activation and optimization of the touch panel's motion and light sensors.
FIG. 43 Sensor Settings page
Modero G4 Touch Panels - Configuration and Programming
The G4 Web Control button toggles between the two G4 activation settings:
• Off - deactivates G4 Web Control on the panel.
• On - activates G4 Web Control on the panel.
Sets the length of time (in minutes) that the panel can remain idle, detecting no cursor
movements, before the G4 Web Control session is terminated.
• Minimum value = Off (panel never times out)
• Maximum value = 4 h (panel times out after 4 hours)
Use this field to enter a unique alpha-numeric string to be used as the panel's display name. If
the Synchronize Device Names option (page 29) is enabled, this field will be disabled.
Use this field to enter the G4 Authentication session password required for VNC access to the
panel.
Use this field to enter the number of the port used by the VNC Web Server. Default = 5900.
via VNC. Press this field to increase the number allowed to connect to this panel. Default = 1.
Displays the number of users currently connected to this panel via VNC.
Settings Pages
27