Bfb; Bim; Bln - AMX Modero G4 Instruction Manual

Programming
"^" Button Commands (Cont.)

^BFB

^BIM

^BLN

66
Set the feedback type of the button. ONLY works on General-type buttons.
Syntax:
"'^BFB-<vt addr range>,<feedback type>'"
Variables:
variable text address range = 1 - 4000.
feedback type = (None, Channel, Invert, On (Always on), Momentary, and Blink).
Example:
SEND_COMMAND Panel,"'^BFB-500,Momentary'"
Sets the Feedback type of the button to 'Momentary'.
Set the input mask for the specified address.
Syntax:
"'^BIM-<vt addr range>,<input mask>'"
Variables:
variable text address range = 1 - 4000.
input mask = Refer to the Text Area Input Masking table on page 124 for character types.
Example:
SEND_COMMAND Panel,"'^BIM-500,AAAAAAAAAA'"
Sets the input mask to ten 'A' characters, that are required, to either a letter or digit (entry is
required).
Set the number of lines removed equally from the top and bottom of a composite video signal. The
maximum number of lines to remove is 240. A value of 0 will display the incoming video signal
unaffected. This command is used to scale non 4x3 video images into non 4x3 video buttons.
Syntax:
"'^BLN-<vt addr range>,<button states range>,<number of lines>'"
Variables:
variable text address range = 1 - 4000.
button states range = 1 - 256 for multi-state buttons (0 = All states, for General buttons
1 = Off state and 2 = On state).
number of lines = 0 - 240.
Example:
SEND_COMMAND Panel,"'^BLN-500,55'"
Equally removes 55 lines from the top and 55 lines from the bottom of the video button.
Modero G4 Touch Panels - Configuration and Programming