Adding A Live Motion Stream To A Touch Panel Page Via An Mxa-Mpl; Commands Through The Command Output Loopback Port (Mxa-Mpl Only) - AMX Modero G4 Instruction Manual

MXA-MP and MXA-MPL Programming
4.
When finished, click OK and then Close to close the Resource Manager.
FIG. 74
Edit Dynamic Image window
5.
After adding the Dynamic Image, assign the image as a Bitmap to a button on a touch panel page.

Adding a Live Motion Stream To A Touch Panel Page via an MXA-MPL

To add a live motion stream to a touch panel page via an MXA-MPL:
1.
In the touch panel page, draw a button to be the video window.
2.
In Button Properties, select MXA-MPL as the video fill (FIG. 75).
FIG. 75 Button Properties
Any video button that has displayed video but is no longer active will display a
snapshot of the last frame displayed.

Commands Through the Command Output Loopback Port (MXA-MPL Only)

If embedding them in TPDesign, send commands involving the MXA-MPL can be sent through the Command Output
Loopback Port. In the Button Properties window, this may be found under the Programming tab.
The touchpanel file attachment example in FIG. 76 below has examples of preview and streaming windows, as well as a
page to give examples of switching resolutions and signal types.
52 Modero G4 Touch Panels - Configuration and Programming