Table of Contents
Advertisement
Network Connection Page
DHCP/Static:
IP Address:
Subnet Mask:
Gateway:
Hostname:
Domain:
Primary DNS:
Secondary DNS:
MAC Address:
Setting Static IP Information
When using DHCP settings for a panel, the DHCP server will automatically populate almost all of the Network
Connections page fields, with the exception of Hostname. When setting the panel for Static, however, this information
must be entered manually. To enter the network connection information:
1.
In DHCP/Static, press the field until the entry reads "Static". This enables all of the editable Network Connections
page fields.
2.
Select the IP Address field to open the Wired IP Address keypad (FIG. 25).
FIG. 25
Wired IP Address keypad
3.
Enter the server's IP address and click OK.
4.
Repeat this procedure with the other fields on the Network Connections page.
5.
When finished, the new connection information will be visible in the Network Connections page.
Entering a New Hostname
In order to facilitate DNS lookup of the panel, you should choose a new hostname for the panel.
If the "Synchronize Device Names" option in the Panel Configuration page (page 29)
is enabled, the hostname is disabled in the Network Connection page and
automatically set to the Device Name.
To add a new hostname, or to change an existing one:
1.
From the Connection & Networks page, select Network Connection to open the Network Connection page.
2.
From the Network Connection page, select Hostname to open the Host Name keyboard (FIG. 26).
Modero G4 Touch Panels - Configuration and Programming
Sets the panel to either DHCP or Static communication modes.
• DHCP is an IP Address assigned to the panel by a DHCP server. If DHCP is selected, the
other Network Connection fields are disabled (see below).
• Static IP is a permanent IP Address assigned to the panel. If Static IP is selected, the other
Network Connection fields are enabled.
Displays the IP address for this panel. If DHCP is enabled, this field will be disabled.
Displays the subnetwork for this panel. If DHCP is enabled, this field will be disabled.
Displays the gateway address for this panel. If DHCP is enabled, this field will be disabled.
Displays the hostname for this panel.
Displays a name to the panel for DNS look-up. If DHCP is enabled, this field will be disabled.
Displays the address of the primary DNS server used by this panel for host name lookups. If
DHCP is enabled, this field will be disabled.
Displays the secondary DNS address for this panel. If DHCP is enabled, this field will be
disabled.
This unique address identifies the Ethernet connection in the panel (read-only).
Settings Pages
17
Advertisement
Table of Contents
