Install Firmware; Resetting To Factory-Installed Firmware - AMX Modero G4 Instruction Manual

A transition to Secure or DoD mode will disable G4 Web Control. Although the security password features are
immediate, a reboot must occur for all the new security mode features to take full effect.
Changing the security setting will also change the G4 Web Control password. This
must be reset from the G4 WebControl on page 26 before you can access the panel
via VNC.

Install Firmware

The Install Firmware page (FIG. 51) allows the touch panel to be reloaded with its original factory-loaded firmware,
installed with a previous version of the current firmware, or to install new firmware from an external storage disk, such
as a USB stick.
FIG. 51 Install Firmware page
Install Firmware Page
Factory:
Previous:
New:

Resetting to Factory-Installed Firmware

In certain circumstances, it may be necessary to uninstall the current firmware on a touch panel and return the panel to its
original factory default firmware. To reset the touch panel to its original factory firmware via the Settings pages:
1.
From the Install Firmware page, select the Factory field.
2.
A System Message window appears, asking "Are you sure you want to install the following firmware?", with the
version "Factory Firmware" listed below (FIG. 52).
FIG. 52 Install Factory Firmware system message
3.
Within five seconds, the Yes button will be enabled. At that time, select Yes to install the factory firmware and No to
return to the Install Firmware page.
4.
If you choose Yes, the touch panel will reboot and restart with the factory default firmware.
To reset the touch panel to its original factory firmware from the panel bootup:
1.
Immediately after the touch panel boots up, the device's splash page appears on the screen (FIG. 53). Press the three
indicator dots within the first three seconds, before they start moving, to reset the firmware.
Modero G4 Touch Panels - Configuration and Programming
Select this to revert the panel back to its original factory-loaded firmware.
Select this to re-install the last previously loaded firmware version.
Select this to install new firmware from an external disk, such as from a USB stick.
Note: if the panel does not detect an external disk containing firmware, this will be disabled.
Settings Pages
33