Fon; Gdi; Giv; Glh - AMX Modero G4 Instruction Manual

"^" Button Commands (Cont.)

^FON

^GDI

^GIV

^GLH

Modero G4 Touch Panels - Configuration and Programming
Set a font to a specific Font ID value for those buttons with a defined address range. Font ID
numbers are generated by the TPDesign4 programmers report.
Syntax:
"'^FON-<vt addr range>,<button states range>,<font value>'"
Variables:
variable text address range = 1 - 4000.
button states range = 1 - 256 for multi-state buttons (0 = All states, for General buttons, 1 = Off
state and 2 = On state).
font value = range = 1 - XXX. Refer to the Default Font Styles and ID Numbers section on
page 61.
Example:
SEND_COMMAND Panel,"'^FON-500.504&510.515,1&2,4'"
Sets the font size to font ID #4 for the On and Off states of buttons with the variable text range of
500-504 & 510-515.
Note: The Font ID is generated by TPD4 and is located in TPD4 through the Main menu. Panel >
Generate Programmer's Report >Text Only Format >Readme.txt.
Change the bargraph drag increment.
Syntax:
"'^GDI-<vt addr range>,<bargraph drag increment>'"
Variables:
variable text address range = 1 - 4000.
bargraph drag increment = The default drag increment is 256.
Example:
SEND_COMMAND Panel,"'^GDI-7,128'"
Sets the bargraph with variable text 7 to a drag increment of 128.
Invert the joystick axis to move the origin to another corner. Parameters 1,2, and 3 will cause a
bargraph or slider to be inverted regardless of orientation. Their effect will be as described for
joysticks.
Syntax:
"'^GIV-<vt addr range>,<joystick axis to invert>'"
Variables:
variable text address range = 1 - 4000.
joystick axis to invert = 0 - 3.
0 1
0 = Normal
1 = Invert horizontal axis
2 = Invert vertical axis
2
3
3 = Invert both axis locations
For a bargraph 1 = Invert, 0 = Non Invert
Example:
SEND_COMMAND Panel,"'^GIV-500,3'"
Inverts the joystick axis origin to the bottom right corner.
Change the bargraph upper limit.
Syntax:
"'^GLH-<vt addr range>,<bargraph hi>'"
Variables:
variable text address range = 1 - 4000.
bargraph limit range = 1 - 65535 (bargraph upper limit range).
Example:
SEND_COMMAND Panel,"'^GLH-500,1000'"
Changes the bargraph upper limit to 1000.
Programming
75