Multiple Ip Interfaces And Vlans Parameters; Table 6-2: Ip Network Interfaces And Vlan Parameters - AudioCodes Mediant 3000 User Manual

Parameter
6.1.2

Multiple IP Interfaces and VLANs Parameters

The IP network interfaces and VLAN parameters are described in the table below.

Table 6-2: IP Network Interfaces and VLAN Parameters

Parameter
Multiple Interface Table
Web: Multiple Interface Table
EMS: IP Interface Settings
[InterfaceTable]
SIP User's Manual
Note:
For this parameter to take effect, a device reset is required.
Enable LAN Watchdog is relevant only if the Ethernet connection
is full duplex.
This ini file table parameter configures the Multiple Interface
table for configuring logical IP addresses. The format of this
parameter is as follows:
[InterfaceTable]
FORMAT InterfaceTable_Index =
InterfaceTable_ApplicationTypes,
InterfaceTable_InterfaceMode, InterfaceTable_IPAddress,
InterfaceTable_PrefixLength, InterfaceTable_Gateway,
InterfaceTable_VlanID, InterfaceTable_InterfaceName;
[\InterfaceTable]
For example:
InterfaceTable 0 = 0, 0, 192.168.85.14, 16, 0.0.0.0, 1,
Management;
InterfaceTable 1 = 2, 0, 200.200.85.14, 24, 0.0.0.0, 200,
Control;
InterfaceTable 2 = 1, 0, 211.211.85.14, 24, 211.211.85.1,
211, Media;
The above example, configures three network interfaces
(OAMP, Control, and Media).
Notes:
Up to 16 logical IP addresses with associated VLANs
can be defined (indices 0-15). However, only up to 8
interfaces can be used for media RTP traffic (assigned to
a Media Realm in the 'SIP Media Realm' table, which in
turn is assigned to an IP Group).
For this ini file table parameter to take effect, a device
reset is required.
Each interface index must be unique.
Each IP interface must have a unique subnet.
Subnets in different interfaces must not be overlapping in
any way (e.g., defining two interfaces with 10.0.0.1/8 and
10.50.10.1/24 is invalid). Each interface must have its
own address space.
Upon device start up, this table is parsed and passes
comprehensive validation tests. If any errors occur during
this validation phase, the device sends an error message
to the Syslog server and falls back to a "safe mode",
using a single IPv4 interface and without VLANs.
266
Description
Description
Document #: LTRT-89707
Mediant 3000