Nokia Ip60 And Nokia Ip60 Wireless Installation - Nokia IP60 User Manual

Nokia IP60 and Nokia IP60 Wireless Installation

Nokia IP60 and Nokia IP60 Wireless Installation

Installing the Nokia IP60 Appliance
To install the IP60 appliance
1. Verify that you have the correct cable type.
For information, see Network Requirements on page 26.
2. Connect the LAN cable:
Connect one end of the Ethernet cable to one of the appliance's LAN ports.
a.
b. Connect the other end to PCs, hubs, or other network devices.
3. Connect the WAN cable:
Connect one end of the Ethernet cable to the appliance's WAN port.
a.
b. Connect the other end of the cable to a cable modem, DSL modem, or office network.
4. Connect the power supply to the appliance's power socket, labeled PWR.
5. Plug the power supply into the wall electrical outlet.
Warning: The IP60 appliance power supply is compatible with either 100, 120 or 230
VAC input power. Verify that the wall outlet voltage is compatible with the voltage
specified on your power supply. Failure to observe this warning may result in
injuries or damage to equipment.
Figure 7: Typical Connection Diagram
50 Nokia IP60 Security Appliance User Guide