Nokia IP60 User Manual page 167

Table 32: Bridged Network Fields
In this field...
Assign to Bridge
Bridge Anti-Spoofing
Allowed IP Range
Spanning Tree Protocol - Port
Cost
Chapter 7: Using Bridges
Do this...
Select the bridge to which the connection should be assigned.
Select this option to enable anti-spoofing.
If anti-spoofing is enabled, only IP addresses within the Allowed
IP Range can be source IP addresses for packets on this
network.
Type the range of IP addresses that should be allowed on this
network.
Note: When assigning IP addresses to machines in a bridged
network segment, the Nokia IP60 DHCP server allocates only
addresses within the allowed IP address range.
To enable clients to move between bridged networks without
changing IP addresses, configure identical IP address ranges
for the desired networks, thus allowing the IP addresses to be
used on either of the bridged networks.
Note: Configuring overlapping or identical allowed IP address
ranges will decrease the effectiveness of anti-spoofing
between the bridged networks.
Type the port's cost.
STP uses the available port with the lowest cost to forward
frames to the root port. All other ports are blocked.
It is recommended to set a lower value for faster links.
This field only appears if the bridge uses STP.
Adding Internal Networks to Bridges
167