Nokia IP60 User Manual page 427

The Command Line page appears.
3. In the upper field, type a command.
You can view a list of supported commands using the command help.
For information on all commands, refer to the Nokia IP60 CLI Reference Guide.
4. Click Go.
The command is implemented.
Using the Serial Console
You can connect a console to the IP60 appliance, and use the console to control the appliance via the
command line.
Note: Your terminal emulation software and your IP60 appliance's Serial port must
be configured for the same speed.
By default, the appliance's Serial port's speed is 57600 bps. For information on
changing the Serial port's speed, refer to the Nokia IP60 CLI Reference Guide.
To control the appliance via a console
1. Connect the serial console to your IP60 appliance's Serial port, using an RS-232 Null modem
cable.
For information on locating the Serial port, see Rear Panel on page 23.
2. Click Network in the main menu, and click the Ports tab.
Chapter 19: Maintenance
Controlling the Appliance via the Command Line
427