Label
Description
Serial
A serial (RS-232) port used for connecting computers in order to access the
Nokia IP60 CLI (Command Line Interface), or for connecting an external dialup
modem.
Depending on the appliance model, this port may have either a DB9 RS232
connector, or an RJ-45 connector. In models with an RJ-45 connector, an RJ-45
to DB9 converter is supplied for your convenience.
Warning: Do not connect an Ethernet cable to the RJ-45 serial port.
WAN
Wide Area Network: An Ethernet port (RJ-45) used for connecting your
broadband modem, a wide area network router, or a network leading to the
Internet.
DMZ/
A dedicated Ethernet port (RJ-45) used to connect a DMZ (Demilitarized Zone)
WAN2
computer or network. Alternatively, can serve as a secondary WAN port or as a
VLAN trunk.
LAN 1-4
Local Area Network switch: Four Ethernet ports (RJ-45) used for connecting
computers or other network devices.
ANT 1/
Antenna connectors, used to connect the supplied wireless antennas .
ANT 2
Front Panel
The Nokia IP60 Wireless appliance includes several status LEDs that enable you to monitor the appliance's
operation.
Figure 5: Nokia IP60 Wireless Appliance Front Panel
For an explanation of the Nokia IP60 Wireless appliance's status LEDs, see the table below.
Table 6: Nokia IP60 Wireless Appliance Status LEDs
LED
State
PWR/SEC
Off
Flashing quickly (Green)
Chapter 1: Introduction
Explanation
Power off
System boot-up
Nokia IP60 Products
27