Nokia IP60 User Manual page 26

Nokia IP60 Products
Network Requirements
10BaseT or 100BaseT Network Interface Card installed on each computer
CAT 5 STP (Category 5 Shielded Twisted Pair) Straight Through Ethernet cable for each
attached device
An 802.11b, 802.11g or 802.11 Super G wireless card installed on each wireless station
A broadband Internet connection via cable or DSL modem with Ethernet interface (RJ-45)
Rear Panel
All physical connections (network and power) are made via the rear panel of your IP60 appliance.
Figure 3: Nokia IP60 Wireless Appliance Rear Panel
Figure 4: Nokia IP60 Wireless Appliance Rear Panel
The following table lists the Nokia IP60 Wireless appliance's rear panel elements.
Table 5: Nokia IP60 Wireless Appliance Rear Panel Elements
Label Description
PWR A power jack used for supplying power to the unit. Connect the supplied power
supply to this jack.
RESET A button used for rebooting the IP60 appliance or resetting the IP60 appliance to
its factory defaults. You need to use a pointed object to press this button.
Short press. Reboots the IP60 appliance
Long press (7 seconds). Resets the IP60 appliance to its factory defaults,
and resets your firmware to the version that shipped with the IP60
appliance. This results in the loss of all security services and
passwords and reverting to the factory default firmware. You will have
to re-configure your IP60 appliance.
Do not reset the unit without consulting your system administrator.
USB Two USB 2.0 ports used for connecting USB-based printers or modems
26 Nokia IP60 Security Appliance User Guide