Pressura RPM10 Operation And Service Manual page 66

Input7 Config Menu
Exh Venturi
SOFTWARE
MENU ITEM
NAME
Reset Calibration Reset Cal
RPM10 and
RPM20
Input7 Config Menu
Exh Switch
SOFTWARE
MENU ITEM
NAME
Low Flow alarm Low Flow Sig
Signal
RPM10 and
RPM20
Input7 Config Menu
Room 2 Key Switch
The Model RPM20 will display a message "Nothing to Configure" when Input 7 is set to Room 2 Key Switch and the user enters the Input7
Config menu.
ITEM DESCRIPTION
The Reset Cal item is used to return to the factory default
calibration, undoing any field calibration adjustments.
When this menu item is entered, the controller will prompt
the user to verify that they want to do this by displaying the
message "Reset Settings to Factory Default?" Entering
YES resets the K-Factor factor for this sensor to defaults.
Entering NO will cancel the reset.
ITEM DESCRIPTION
The Low Flow Sig item sets the signal the Model RPM10
and RPM20 Room Pressure Controller will receive to
indicate a low exhaust flow condition.
ITEM DESCRIPTION
DEFAULT
ITEM RANGE
VALUE
None N/A
DEFAULT
ITEM RANGE
VALUE
Open, Closed Close