Interface Menu - Pressura RPM10 Operation And Service Manual

Alarm Config Menu
SOFTWARE
MENU ITEM
NAME
Mute Timeout Mute Time
RPM10 and
RPM20
Relay2 Output Relay 2 Out
Signal
RPM10 and
RPM20
Relay 2 Output Relay 2 Dir
Direction

Interface Menu

SOFTWARE
MENU ITEM
NAME
Network Comm Type
Communications
Protocol
RPM10 and
RPM20
ITEM DESCRIPTION
The Mute Time item sets the length of time the audible
alarm will be silenced if the mute button is pressed. The
Mute Time can be set from 1 to 60 minutes.
The Relay 2 Out item sets desired alarm output to be
used with Relay 2. If set to:
HIGH ALARM the PresSura monitor will activate the relay
if a high alarm condition exists.
NEGATIVE ROOM the PresSura monitor will activate the
relay when the mode for Room 1 is Negative.
POSITIVE ROOM the PresSura monitor will activate the
relay when the mode for Room 1 is Positive.
The Relay 2 Dir item sets desired signal output to be
used with Relay 2.
If Relay 2 Out is set to HIGH ALARM
If Relay 2 Out is set to NEGATIVE ROOM or
POSITIVE ROOM:
ITEM DESCRIPTION
The Comm Type item selects the communications protocol
used to interface with the building management system.
NOTE: LON can only be selected on Model RPM20
monitors with LONworks.
Modbus and BACnet will only appear on
Model RPM20 monitors without LON and on all
Model RPM10 monitors.
DEFAULT
ITEM RANGE
VALUE
1 to 60 Minutes 5 Minutes
High Alarm
High Alarm
Negative Room
Positive Room
OK = OPEN OK = OPEN
OK = CLOSED
NO ISO = OPEN NO ISO = OPEN
NO ISO = CLOSED
DEFAULT
ITEM RANGE
VALUE
®
Modbus
RPM10: Modbus
®
BACnet
®
RPM20: Modbus
®
BACnet
LON