Assemble - Taylor-Dunn C0-425-36 Operation, Troubleshooting And Replacement Parts Manualooting And Replacement Parts Manual

Maintenance, Service, and Repair
12. Depress and turn the tilt spring about 30º and remove the retainer, tilt spring and the spring
guide.
13. Thread an 8-32 machine screw into the pivot pins and pull them out.
14. Install the tilt lever and pull it up to release the tilt housing from the column.
15. Remove the upper shaft inner race and bearing #2.
16. Remove the steering shaft.
17. Rotate the upper shaft 90º and separate it from the upper shaft
18. Rotate the plastic CV bushing 30º and remove it from the steering shaft.
19. If replacing the bearings, remove the inner race from the steering shaft and outer races from the
tilt housing.
20. Remove the roll pin from the lower bushing and the lower bushing from the column.

Assemble

Assemble in reverse order.
Use a soft faced hammer to install the pivot pins.
a.) Pack the upper steering shaft bearings with grease.
b.) Apply grease on the plastic CV bushings.
c.) Lightly grease the pivot pins and pivot spring guide pivot point.
d.) Lightly grease the turn signal switch contacts.
e.) Use locktite on lower U-joint set screws.
Steering wheel adaptor
Circlip
Retaining plate
Turn switch
1/4 cut flat washer
Upper bearing #1
Tilt housing
Pivot pin
Steering
Tilt spring retainer
Tilt spring
Tilt spring guide
Plastic CV bushing
Page 10
Upper bearing #2
Upper steering shaft