Special Tools - Taylor-Dunn C0-425-36 Operation, Troubleshooting And Replacement Parts Manualooting And Replacement Parts Manual

Special Tools

Special Tools
D E S C R I P T I O N
Pinion Seal Installation Tool
Chain Case Centering Tool
Test Light
Accelerator Test Harness
PMC Test Kit
Curtis PMC Handheld
P r o g r a m m e r
GE EV1 Analyzer
Disc Brake Boot Installation
Tool
Pin Removing Tool
Pin Removing Tool
H y d r o m e t e r
Battery Filler
Retaining Plate Depressor
Fork Collar Weld Jig
S e c o n d a r y S h e a v e H o l d e r
Solder Kit For Field Stud
Pinion Gear Holding Tool
P U R P O S E
Used to install the pinion seal on all chain drive trucks
w i t h t h e b a n d s t y l e b r a k e o r t h e s p e e d s e n s o r o n t h e
chain case cover.
Used to center the chain case on the pinion shaft on all
chain drive trucks with the band style brake or the speed
sensor on the chain case cover. Includes instructions.
Used for testing electrical circuits. Powered by the truck
batteries, switchable for 12, 24, 36, and 48 volts.
U s e d t o t e s t t h e s o l i d s t a t e a c c e l l e r a t o r m o d u l e p a r t
number series 62-033-XX.
I n c l u d e s 6 2 - 0 2 7 - 0 0 , 6 2 - 0 2 7 - 3 1 , a n d s u p p l e m e n t a r y
t r o u b l e s h o o t i n g m a n u a l M 3 - 0 0 1 - 0 6 . F o r c o n t r o l l e r s
equipped with pins labeled KSI and #2 only.
U s e d t o t e s t a n d p r o g r a m t h e 6 2 - 2 1 5 - 0 0 P M C s p e e d
control used on early model C4-25 Huskey.
Used to test the GE EV1 speed control.
Used to install the rubber boot on all disc brake bodies.
Used to remove pins and sockets from AMP connectors.
U s e d t o r e m o v e p i n s a n d s o c k e t s f r o m M O L E X
connectors.
Used to check the specific gravity of battery electrolyte.
Used to safely add water to batteries.
U s e d t o h o l d d o w n t h e r e t a i n i n g p l a t e w h e n
disassembling the steering gear on trucks equipped with
the tilt steering.
Used when replacing the fork collar on models MX-600
and SS5-36.
Used to hold the secondary sheave (pulley) from turning
on models R6-80 and B6-10 with the Yamaha drive.
Used to solder the aluminum field wire to the field stud.
For use on motors with soldered connections only.
Used to align the Pinion Gear and Case during assembly
and disassembly.
APPENDIX A PAGE 2
P A R T N U M B E R
43-201-50
41-532-50
62-027-00
62-027-31
62-027-60
62-027-10
62-027-20
41-350-13
75-440-55
75-442-55
77-200-00
77-201-00
96-500-39
96-500-40
96-500-14
70-210-63
96-500-42