Repair The Steering Gear - Taylor-Dunn C0-425-36 Operation, Troubleshooting And Replacement Parts Manualooting And Replacement Parts Manual

Maintenance, Service, and Repair

REPAIR THE STEERING GEAR

Disassembly
NOTE: The steering gear must be removed from the vehicle for this
NOTE: The steering gear is packed with grease. Only perform maintenance
Refer to the illustration at the end of this section for a blown up view of the steering gear assembly.
1. Center the steering gear.
A. Turn the steering shaft all of the way in one direction.
B. While counting the rotation, turn the steering shaft all of the way in the opposite direction.
C. Turn the steering shaft 1/2 the number of turns in the original direction.
2. Remove the worm bearing adjuster locking ring and
the worm bearing adjuster.
3. Remove the side cover/pitman shaft assembly by
removing the three side cover bolts and then pulling
the assembly out of the housing.
NOTE: The side cover/pitman shaft assembly
procedure. Refer to Replace the Steering Gear section for
information regarding removing the steering gear.
on the steering gear in an area that will contain any grease that
may spill out of the steering gear when it is disassembled.
normally does not have to be
disassembled.
Steering Page 16