Adjust The Steering Gear (Saginaw) - Taylor-Dunn C0-425-36 Operation, Troubleshooting And Replacement Parts Manualooting And Replacement Parts Manual

Maintenance, Service, and Repair

ADJUST THE STEERING GEAR (SAGINAW)

NOTE: In some vehicle configurations it may be necessary to remove the
6. Raise the front of the vehicle and support with jack stands.
7. Disconnect the drag link from the pitman arm.
NOTE: Refer to Replace the Ball Joints section for information regarding
8. Loosen the gear lash jam nut and the worm bearing
adjuster jam nut.
9. Unscrew the gear lash adjuster all of the way to the
stop.
10. Loosen the worm bearing adjuster and then tighten
just enough to remove all end play from the input
shaft and then an additional 1/8 turn more.
11. While holding the worm bearing adjuster so that it
cannot turn, tighten the worm bearing adjuster jam
nut.
steering gear to perform this procedure. Refer to
Steering Gear
for information regarding removing the steering
gear.
1. Make sure the key-switch is in the "OFF" position, then remove
the key.
2. Place the forward-reverse switch in the center "OFF" position.
3. Set the park brake.
4. Place blocks under the rear wheels to prevent vehicle movement.
5. Unplug the main battery connector.
Always use a lifting strap, hoist, and jack stands, of adequate capacity
to lift and support the vehicle. Failure to use lifting and support devices
of rated load capacity may result in serious bodily injury.
removing the ball joint from the drag link.
Steering
Replace the
Page 6