Adjust The Parking Brake; Wheel Park Brake - Taylor-Dunn C0-425-36 Operation, Troubleshooting And Replacement Parts Manualooting And Replacement Parts Manual

ADJUST THE PARKING BRAKE

Wheel Park Brake

The parking brake is actuated through a pin in the center
of the rear left and right brake body on the rear axles.
6. Release the park brake.
7. Loosen the jam nuts on the park brake linkage.
8. Adjust the linkage to remove all slack for the park
brake cables.
9. Tighten the jam nuts on the park brake linkage.
10. Set the park brake.
11. Reconnect the main battery connector.
12. Remove blocks from behind the wheels.
13. Release the park brake and test drive the vehicle.
Maintenance, Service, and Repair
1. Make sure the key-switch is in the "OFF" position, then remove the
key.
2. Place the forward-reverse switch in the center "OFF" position.
3. Set the park brake.
4. Place blocks under the rear wheels to prevent vehicle movement.
5. Unplug the main battery connector.
Brakes Page 7