Replace The Shocks; Front Or Rear - Taylor-Dunn C0-425-36 Operation, Troubleshooting And Replacement Parts Manualooting And Replacement Parts Manual

Maintenance, Service, and Repair

REPLACE THE SHOCKS

Front or Rear

It is recommended to replace all four front shock as a set.
NOTE: On some vehicles it may be required to remove the wheel to gain
6. Some vehicles may require that the wheels be lifted off of the ground and supported with jack
stands to replace the shocks.
7. Remove the upper and lower shock bolts.
8. Remove the shock from the vehicle.
NOTE: If the shock that was removed is to be
9. Install the shock in reverse order.
10. Lower the vehicle.
11. Reconnect the main battery connector.
12. Remove the blocks from behind the wheels.
13. Release the parking brake and test drive the vehicle.
access to the shock mounting bolts. Refer to Tires and Wheels
section for information regarding removing the wheels.
1. Make sure the key-switch is in the "OFF" position, then remove
the key.
2. Place the forward-reverse switch in the center "OFF" position.
3. Set the park brake.
4. Place blocks under the rear wheels to prevent vehicle movement.
5. Unplug the main battery connector.
Always use a lifting strap, hoist, and jack stands, of adequate capacity
to lift and support the vehicle. Failure to use lifting and support devices
of rated load capacity may result in severe bodily
reinstalled:
A. Inspect the shaft where it enters the shock
body for any signs of leakage. If any sign
of leakage is seen, then the shock must
be replaced.
B. Inspect the upper and lower shock
bushings. If any signs of damage or wear
are seen, then the shock must be
replaced.
Suspension Page 4