Steering Column; Disassemble; Replace The Tilt Steering Assembly - Taylor-Dunn C0-425-36 Operation, Troubleshooting And Replacement Parts Manualooting And Replacement Parts Manual

STEERING COLUMN

NOTE: The steering column does not have to be removed from the vehicle unless the lower steering shaft
or bushing is to be replaced. Refer to
regarding removing the steering column.
Perform the following 5 steps if the steering column is not removed from the vehicle.

Disassemble

6. Depress the retaining plate and remove the retaining plate circlip.
7. Remove the retaining plate and the horn button contact plate and spring.
8. Remove he three button head screws holding the turn signal switch.
9. If replacing the turn switch, remove the pins from the harness connector and pull the switch out
of the column.
10. Remove the upper shaft inner race and bearing #1.
11. Remove the two Torx head screws in the housing and remove the housing. Catch the flat
washer as it falls out.
Maintenance, Service, and Repair

Replace the Tilt Steering Assembly

1. Make sure the key-switch is in the "OFF" position, then remove
the key.
2. Place the forward-reverse switch in the center "OFF" position.
3. Set the park brake.
4. Place blocks under the rear wheels to prevent vehicle movement.
5. Unplug the main battery connector.
Steering wheel adaptor
Circlip
Retaining plate
Turn switch
1/4 cut flat washer
Upper bearing #1
Tilt housing
Pivot pin
Steering
Tilt spring retainer
Tilt spring
Tilt spring guide
Plastic CV bushing
Page 9
section for information
Upper bearing #2
Upper steering shaft