Adjust The Service Brakes; Two Or Four Wheel Hydraulic Disc Brakes; Adjust The Brake Linkage - Taylor-Dunn C0-425-36 Operation, Troubleshooting And Replacement Parts Manualooting And Replacement Parts Manual

ADJUST THE SERVICE BRAKES

Two or Four Wheel Hydraulic Disc Brakes

The hydraulic disc brake system is automatically adjusted. A low brake pedal or lack of braking power
could be caused by:
•
Brake fluid level low in the master cylinder. See
•
Air in the brake lines. See
•
Worn brake pads. See
•
Worn brake rotor. See
•
Binding brake pedal linkage.
If you are experiencing a low brake pedal or lack of braking power, the entire brake system should be
inspected.

ADJUST THE BRAKE LINKAGE

6. Tighten the master cylinder push rod pivot bolt so
that the push rod may pivot freely with no side play.
See the illustration to the right.
Maintenance, Service, and Repair
Bleed the Brakes
Inspect the Service Brake
Inspect the Service Brake
1. Make sure the key-switch is in the "OFF" position, then remove
the key.
2. Place the forward-reverse switch in the center "OFF" position.
3. Set the park brake.
4. Place blocks under the rear wheels to prevent vehicle movement.
5. Unplug the main battery connector.
7. Tighten the spring mounting bolt and the pedal stop bolt so
that one thread shows beyond the locknut. See arrows in
the illustraition to the left.
Brakes
Check the Master Cylinder Fluid
section.
section.
section.
Pivot bolt
Page 5
section.
Push rod