Throttle Linkage Adjustments - Taylor-Dunn C0-425-36 Operation, Troubleshooting And Replacement Parts Manualooting And Replacement Parts Manual

Maintenance, Service, and Repair

THROTTLE LINKAGE ADJUSTMENTS

6. Adjust the accelerator pedal arm pivot nut so that there is 0.005" clearance between the nut and
flat washer.
7. Make sure the accelerator pedal arm is in the fully released position. See arrow 1 in the
illustration.
8. Adjust the throttle rod so that the accelerator module arm has 0.010" clearance between the
arm and the accelerator module bracket. See arrow 2 in the illustration.
9. Reconnect the main battery connector.
10. Remove the blocks from the wheels and test drive the vehicle.
Accelerator
Module
Pivot nut
1
Accelerator
Arm
1. Make sure the key-switch is in the "OFF" position, then remove
the key.
2. Place the forward-reverse switch in the center "OFF" position.
3. Set the park brake.
4. Place blocks under the rear wheels to prevent vehicle movement.
5. Unplug the main battery connector.
2 (see magnified view at right)
Pivot nut
Throttle rod
0.005"
Throttle Linkage Page 2
2
0.010