Assemble - Taylor-Dunn SC-090-24 Operation, T Roubleshooting And Replacement Parts Manual

Maintenance, Service, and Repair
15. Remove the o-rings from each end of the intermediate
shaft.
16. Remove the circlip from the input shaft.
17. Remove the input shaft from the housing.
18. Press the bearings off of the input shaft.
19. Remove the o-rings from both sides of the intermediate
shaft bore and the input shaft bore and discard the o-rings.

Assemble

Note: When pressing bearings, do not press against or support the outer race as this will damage the
bearing.
Note: All snap rings should fit tightly into their grooves. If a snap ring is loose, then it must be replaced.
Note: All internal components should fit easily together. Do not hit any shaft or component with a hard
metal hammer or punch.
Note: Pre-lube all bearings, seals and o-rings before assembly.
1. Thoroughly clean all components as well as the inside of the housing.
2. Press new bearings onto the input shaft and differential case.
Transmission
Page 6