Replace Front Brake Pads - Taylor-Dunn C0-425-36 Operation, Troubleshooting And Replacement Parts Manualooting And Replacement Parts Manual

REPLACE FRONT BRAKE PADS

NOTE: It is recommended that both the left and right brake pads be replaced
NOTE: Installing new brake pads will raise the brake fluid level in the
6. Thoroughly clean the area around the master
cylinder cap.
7. Remove fluid from the master cylinder until it is 1/
2 full.
8. Raise the front of the vehicle and support with jack
stands.
9. Remove the tire/wheel assembly. Refer to
removing the tire and wheel assembly.
Maintenance, Service, and Repair
as a set.
Current Taylor-Dunn
the possibility that the original brakes were replaced with aftermarket
parts containing asbestos. Since this possibility exists, all brake parts
should be handled as if they contain asbestos. Refer to appendix C
for recommended handling precautions.
master cylinder.
1. Make sure the key-switch is in the "OFF" position, then remove
the key.
2. Place the forward-reverse switch in the center "OFF" position.
3. Set the park brake.
4. Place blocks under the rear wheels to prevent vehicle movement.
5. Disconnect the main positive and negative cables at the batteries.
Always use a lifting strap, hoist, and jack stands, of adequate capacity
to lift and support the vehicle. Failure to use lifting and support devices
of rated load capacity may result in severe bodily injury.
Brakes
brakes are asbestos free. However, there is
®
Tires and Wheels
Page 13
section for information on