Taylor-Dunn C0-425-36 Operation, Troubleshooting And Replacement Parts Manualooting And Replacement Parts Manual page 96

Maintenance, Service, and Repair
10. Install in reverse order.
11. Fill the master cylinder with brake fluid from a sealed
container.
12. Pump the brake pedal a short distance of one to
two inches until no bubbles are seen coming from
the inlet ports inside of the master cylinder chamber.
13. If the vehicle was raised, lower it to the ground.
14. Bleed the brakes. refer to Bleed the Brakes section
for information regarding bleeding the brakes.
15. Reconnect the main positive and negative cables
at the batteries.
16. Remove the blocks from behind the wheels.
17. Release the park brake and test drive the vehicle.
•
Only use DOT 3 brake fluid from a new sealed container.
•
DOT 3 brake fluid is corrosive and will damage paint finishes.
•
Dispose of brake fluid in accordance with local state and federal
regulations.
•
Read and follow all warnings on the brake fluid container.
Cutaway of typical master cylinder showing
R
Brakes Page 22
Plunger
Master Cylinder
1/8"
the push rod clearance
Push Rod