Taylor-Dunn C0-425-36 Operation, Troubleshooting And Replacement Parts Manualooting And Replacement Parts Manual page 29

SAFETY RULES AND OPERATING INSTRUCTIONS
Run Time Hours icon
Fault Code Description
01004 Discharged battery or defective wiring.
01005 Speed control overheated.
01008 Optional speed encoder or speed encoder
wiring defective
02000 Start up switches not operated in the correct
order or a defective switch.
02001 Defective wiring
04003 Start up switches not operated in the correct
order or a defective switch.
04004 Both the forward and reverse directions are
selected at the same time
04005 Start up switches not operated in the correct
order or a defective switch.
04006 Accelerator pedal depressed before the seat
interlock switch is closed
04007 -
04009 Discharged battery or defective wiring.
04010 Battery voltage too high
04011 Personality fault
04012 Personality fault
04013 Defective wiring or batteries
05000 Line contactor coil or wiring shorted
05006 MOSFET shorted
05008 Line contactor welded contacts or wiring
shorted
05009 MOSFET shorted
05046 Line contactor contacts open or defective
wiring
Run Time Hours: After the initial 5-seconds, the Run
Time Hours will be displayed as indicated by the Run
Time Hours Indicator located at the left of the display.
The icon represents a motor symbol with a "T" in the
center.
Speed controller status: The display will indicate a fault
code whenever the control system logic detects a problem
with the control system. A fault code is being displayed
whenever the Fault Code Indicator (the letter 'F') is visible
at the left of the numeric display. Refer to the table below
for a list of fault codes and their descriptions.
Safety Rules
Corrective action
Charge the battery. If the battery is
good, check wiring to the controller.
Allow the controller to cool off. May be
the result of an overloaded vehicle or an
obstruction to the controller heat sink.
Repair as required
Reset switches and start again.
Refer to troubleshooting
Reset switches and start again.
Check the forward/ switch and wiring
for shorts.
Reset switches and start again.
Recycle start up switches and try again.
Possible defective seat switch.
Defective wiring
Charge the battery. If the battery is
good, check wiring to the controller.
Incorrect battery installed.
Reprogram the controller
Reprogram the controller
Refer to troubleshooting
Replace contactor or repair wiring
Refer to troubleshooting
Replace contactor or repair wiring
Refer to troubleshooting
Replace contactor or repair wiring.
Could also be result of open circuit
breaker
Page 11