Taylor-Dunn C0-425-36 Operation, Troubleshooting And Replacement Parts Manualooting And Replacement Parts Manual page 119

9. Remove the nuts from the rear suspension
bushing bolts.
10. Raise the rear of the vehicle and support with jack stands.
NOTE: Do not raise the vehicle so high to where the rear wheels come off
of the ground.
Always use a lifting strap, hoist, and jack stands, of adequate capacity
to lift and support the vehicle. Failure to use lifting and support devices
of rated load capacity may result in severe bodily injury.
11. Remove the swing arm pivot bolts and roll the
transmission assembly out from under the
vehicle.
12. Install the transmission assembly in reverse order of removal.
a. Bleed the brake system. Refer to section
the brakes.
b. Adjust the park brake. Refer to section
the park brake.
13. Lower the vehicle.
14. Set the park brake.
15. Reconnect the main positive and negative cables at the batteries.
16. Remove the blocks from behind the wheels.
17. Release the park brake and test drive the vehicle.
Maintenance, Service, and Repair
Brake Service
Brake Service
Transmission Page 9
for information regarding bleeding
for information regarding adjusting