Motor Removal And Installation; Motor Inspection - Taylor-Dunn C0-425-36 Operation, Troubleshooting And Replacement Parts Manualooting And Replacement Parts Manual

MOTOR REMOVAL AND INSTALLATION

Transmission
See the

MOTOR INSPECTION

Disassembly
1. Remove the motor from the vehicle. See the
the motor.
2. Remove the brush cover and pull the brushes out away from the commutator.
3. Remove the dust cap from the rear motor housing.
4. Place the motor in a press, and press the armature out of the rear bearing.
NOTE: Removing the armature will damage the motor bearing. The motor
5. Remove the housing screws from the rear motor housing and remove the housing from the
motor.
6. Remove the nuts from the armature studs and remove the two brush assemblies.
7. Remove the bearing circlip and press the motor bearing out of the housing and discard.
Inspection
1. Measure the length of each motor brush.
• If any one brush is less than or equal to the service limit specified
in section
replaced. Refer to
information regarding replacing the motor brushes.
section for information on removing or installing the motor.
bearing should be replaced whenever the armature is removed.
Service Limits
, then all four brushes should be
Replacing the Brushes
Motor
Motor Service
Transmission
section for information on removing
section for
Page 3