Alternate Programming For Homelink To The Prodrive - Wayne-Dalton Prodrive 3220C Installation Instructions And Owner's Manual

NOTE: This Step can only be done on automobiles equipped with the
®
HomeLink System.
NOTE: Programming HomeLink
Transmitter that is programmed to the opener (the wallstation and
transmitter(s) supplied with the opener, come pre-programmed from
the factory). Any additional wallstation(s) or transmitter(s) will need to
be programmed to the opener, see page 33.
IMPORTANT: Use the programming instructions provided with your
vehicle first. Follow these instructions if the HomeLink
learn the transmitter, when using the vehicle's instructions.
NOTE: Vehicle may need to be in accessory position when
programming. Check car owner's manual.
NOTE: HomeLink ® is a registered trademark of Johnson Controls.
Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need
Alternate Programming for HomeLink
® requires a Wayne-Dalton
® unit does not
® to the Prodrive
Programming/Training HomeLink
WARNING
GARAGE DOOR MAY OPERATE DURING PROGRAMMING. TO AVOID
POSSIBLE SEVERE OR FATAL INJURY, PLACE THE EMERGENCY
DISCONNECT HANDLE IN THE MANUAL OPERATED POSITION.
1. Pull the manual disconnect to put the opener in the disengaged
position.
2. Press and hold the two outside buttons on the HomeLink
the HomeLink ® indicator light begins to flash rapidly (approx. 20
seconds), then release both buttons. (Do not perform this step to train
additional hand-held transmitters.) NOTE: This operation erases all
previously learned transmitters and that you need to re-teach any other
transmitters to your HomeLink
3. Hold the end of the Wayne-Dalton hand-held transmitter
approximately 1 to 3 inches away from the HomeLink
keeping the HomeLink ® indicator light in view.
4. Use the large button on the Wayne Dalton transmitter.
Simultaneously press and hold desired Homelink
Wayne Dalton transmitter large button. Continue to press both buttons
counting LED flashes on the HomeLink
LED flashes the LED will either come on solid or do one "quick flash";
when either of these occur release both Wayne Dalton transmitter and
®
HomeLink buttons.
Teaching HomeLink ® to the opener
5. Press the program switch on the opener. The red program status
light on the opener and light will turn on and remain lit for one minute,
indicating that it is ready to learn.
®
6. Press the HomeLink button used in Step 4 above for 1 to 3
seconds. The program status light on the opener will turn on and off
three times indicating a successful learn.
7. Press the HomeLink ® the opener will activate and the trolley will
travel towards open, the next activation will cause the trolley to travel to
the closed position and reengage, subsequent operations will move the
door.
®
® Unit
®
®
unit by repeating steps 3 - 6 below.
® surface
® button and the
®
module; between 50 to 60
unit until
31