Honda 2005-2008 RX500 FA Service Manual page 290

'61HN252' by American Honda Motor Co. - Page 290 of 540
[2005-2008] [TRX500 FA/FGA]
FRONT WHEEL/SUSPENSION/STEERING
14-22
1 of 1
KNUCKLE
Remove the snap ring and the inner dust seal.
Set the knuckle and special tools with "A" mark side
of the remover/installer facing to the ball joint, in a
vise as shown.
Press the ball joint out of the knuckle.
TOOLS:
Ball joint remover/installer
Attachment, 28 x 30 mm
Set the knuckle and special tools with "B" mark side
of the remover/installer facing to the ball joint in a
vise as shown.
Press the ball joint into the knuckle until it is fully
seated.
TOOLS:
Ball joint remover/installer
Attachment, 15 mm I.D.
· If you feel strong resistance when lowering the
press, stop. Reset the attachment of the tool so
that the ball joint head can go into the hollow of
the attachment and try again.
Install the snap ring with the chamfered edge facing
in.
Install a new inner dust seal (page 14-23).
http://services.honda.com/ServiceManual/SVC_MNL/61HN253/61HN2...
INNER DUST SEAL
REMOVER/INSTALLER
07WMF-HN00100
07946-1870100
"A" MARK
REMOVER/INSTALLER
07WMF-HN00100
07746-0020200
"B" MARK
SNAP RING
ATTACHMENT
ATTACHMENT
INNER DUST SEAL
SNAP RING
3/9/2008 11:04 PM