Temperature Indicator - Honda 2005-2008 RX500 FA Service Manual

'61HN252' by American Honda Motor Co. - Page 455 of 540
[2005-2008] [TRX500 FA/FGA]

TEMPERATURE INDICATOR

1 of 1
Install the sensor into the fuel tank while aligning
the groove in the plate with the boss on the fuel
tank.
Install and tighten the bolts.
Install the removed parts in the reverse order of
removal.
FUEL LEVEL SENSOR INSPECTION
Remove the fuel level sensor (page 22-15).
Disconnect the fuel level sensor 2P connector and
connect the ohmmeter to the sensor side connector
terminals.
Measure the fuel level sensor resistance with the
float at the top "FULL" and bottom "RESERVE" posi-
tion.
Resistance (20°C/68°F)
FLOAT POSITION
TOP "FULL"
204 210 Ω
BOTTOM "RESERVE"
SYSTEM INSPECTION
· The oil/coolant temperature indicator should
come on for a few seconds when the ignition
switch is turned ON and the indicator should
extinguish shortly.
Check that the neutral indicator or reverse indicator
function properly.
· If they do not function, perform the power/
ground line inspection (page 22-13).
· If they function, check the following.
http://services.honda.com/ServiceManual/SVC_MNL/61HN253/61HN2...
BOLTS
CONNECTORS
57Ω
TEMPERATURE INDICATOR
LIGHTS/METERS/SWITCHES
FUEL LEVEL SENSOR
FLOAT
TOP
(FULL)
BOTTOM
(RESERVE)
22-17
Align
3/9/2008 11:24 PM