Honda 2005-2008 RX500 FA Service Manual page 343

'61HN252' by American Honda Motor Co. - Page 343 of 540
[2005-2008] [TRX500 FA/FGA]
1 of 1
Apply grease to the brake cam sliding surface and
anchor pins.
Install the brake cam into the brake panel.
Apply engine oil to the felt seal and install it.
Install the return spring.
Install the indicator plate aligning the wide tooth on
the plate with the wide groove on the brake cam.
Install the brake arm, aligning the punch marks on
the brake arm and cam.
Hook the return spring end onto the brake arm.
Tighten the brake arm pinch bolt/nut to the specified
torque.
TORQUE: 20 N·m (2.0 kgf·m, 14 lbf·ft)
Install the brake shoes in their original positions
with the spring as shown.
Install the anchor pin setting plate with its cham-
fered side (rolled edge side) facing in.
http://services.honda.com/ServiceManual/SVC_MNL/61HN253/61HN2...
FELT SEAL
INDICATOR PLATE
BRAKE ARM
PUNCH MARKS
SPRINGS
BRAKE SYSTEM
BRAKE CAM
RETURN SPRING
Align
RETURN SPRING
BOLT/NUT
SETTING PLATE
BRAKE SHOES
16-25
3/9/2008 11:11 PM