Differential Removal - Honda 2005-2008 RX500 FA Service Manual

'61HN252' by American Honda Motor Co. - Page 362 of 540
[2005-2008] [TRX500 FA/FGA]
FRONT DRIVING MECHANISM

DIFFERENTIAL REMOVAL

17-14
1 of 1
Install the tie-rod onto the knuckle.
Install a new tie-rod ball joint nut and tighten it by
holding the ball joint stud flats with an open end
wrench.
TORQUE: 54 N·m (5.5 kgf·m, 40 lbf·ft)
Install a new cotter pin.
Tighten the axle nut to the specified torque and fur-
ther tighten until its grooves align with the cotter
pin hole.
TORQUE: 78 N·m (8.0 kgf·m, 58 lbf·ft)
Install a new cotter pin.
Install the front wheel (page 14-12).
Drain the differential oil (page 3-18).
Remove the following:
front fender/inner fender (page 2-11)
left drive shaft (page 17-7)
Remove the two bolts, guard plate and front vehicle
speed sensor.
Remove the two bolts and clutch cover.
http://services.honda.com/ServiceManual/SVC_MNL/61HN253/61HN2...
TIE-ROD
BALL JOINT NUT
AXLE NUT
BOLTS
FRONT SPEED SENSOR
CLUTCH COVER
BOLTS
COTTER PIN
COTTER PIN
GUARD PLATE
3/9/2008 11:13 PM