Mode Select Switch - Honda 2005-2008 RX500 FA Service Manual

Table of Contents

'61HN252' by American Honda Motor Co. - Page 517 of 540

[2005-2008] [TRX500 FA/FGA]

MODE SELECT SWITCH

Turn the ignition switch OFF.

Disconnect the ECM 21P (Black) connector.

Check for continuity between the ECM connector

terminals in each switch position.

Continuity should exist between the color coded

wires as follows:

If the continuity is abnormal, disconnect the mode

select switch 4P (Black) connector, and perform the

inspection at the 4P (Black) connector in the same

manner as the previous step.

· If the continuity at the ECM is abnormal and con-

tinuity at the 4P connector is normal, check for an

open or short circuit, or loose or poor connector

· If the both continuities are abnormal, replace the

mode select switch.

Remove the handlebar cover

(page 14-6).

Remove the screw.

Remove the mode select switch from the cover

while pushing in the stoppers.

Install the new switch by aligning the locating tab

with the groove in the cover.

Install and tighten the screw.

http://services.honda.com/ServiceManual/SVC_MNL/61HN253/61HN2...

ECM 21P (BLACK) CONNECTOR

'05, '06 shown:

4P (BLACK) CONNECTOR

3/9/2008 11:30 PM

Table of Contents