Honda 2005-2008 RX500 FA Service Manual page 406

Table of Contents

'61HN252' by American Honda Motor Co. - Page 406 of 540

[2005-2008] [TRX500 FA/FGA]

REAR DRIVING MECHANISM

Do not get grease

on the brake shoe

Apply molybdenum disulfide grease to a new hub

dust seal lip and install it into the left wheel hub

until it is fully seated.

Install the wheel hub to the left splines.

Install the hub nut and tighten it to the specified

torque and further tighten until its grooves align

with the cotter pin hole.

TORQUE: 137 N·m (14.0 kgf·m, 101 lbf·ft)

Install a new cotter pin.

Coat a new O-ring with grease and install it into the

brake panel groove.

Install the brake panel assembly onto the axle.

Install new brake panel nuts and tighten them.

TORQUE: 44 N·m (4.5 kgf·m, 33 lbf·ft)

Install the brake cables into the cable holders on the

brake panel (upper holder for lever brake cable and

lower holder for pedal brake cable).

Install the cable springs onto the cables. Connect

the brake cables to the brake arm with the joint pins

and adjusting nuts.

Install the rear brake drum

(page 16-26).

Fill the gear case with the recommended oil

http://services.honda.com/ServiceManual/SVC_MNL/61HN253/61HN2...

BRAKE CABLES

LEFT WHEEL HUB

ADJUSTING NUTS

3/9/2008 11:19 PM

Chapters

Table of Contents