Honda 2005-2008 RX500 FA Service Manual page 97

Table of Contents

Advertisement

'61HN252' by American Honda Motor Co. - Page 97 of 540
[2005-2008] [TRX500 FA/FGA]
SERVICE INFORMATION
GENERAL
Used engine oil may cause skin cancer if repeatedly left in contact with the skin for prolonged periods. Although this is
unlikely unless you handle used oil on a daily basis, it is still advisable to thoroughly wash your hands with soap and
water as soon as possible after handling used oil.
·
This section covers service of the oil pump and oil cooler.
·
For oil level check, oil change and filter replacement, refer to
·
The service procedures in this section can be performed with the engine oil drained.
·
The service procedures in this section can be performed with the engine installed in the frame.
·
When removing and installing the oil pump, use care not to allow dust or dirt to enter the engine.
·
If any portion of the oil pump is worn beyond the specified service limits, replace the oil pump as an assembly.
·
After oil pump, oil cooler and/or oil hoses have been installed, check that there are no oil leaks and that oil pressure is
correct.
SPECIFICATIONS
Engine oil capacity
Recommended engine oil
Oil pressure 80°C(176°F)
Oil pump rotor
TORQUE VALUES
Oil gallery sealing bolt (front crankcase cover)
Engine oil temperature (EOT) sensor
1 of 1
page 3-12.
ITEM
After draining
After draining/filter
change
After disassembly
At 1,400 rpm (min
)
-1
At 5,000 rpm (min
)
-1
Tip clearance
Body clearance
Side clearance
34 N·m (3.5 kgf·m, 25 lbf·ft)
18 N·m (1.8 kgf·m, 13 lbf·ft)
http://services.honda.com/ServiceManual/SVC_MNL/61HN253/61HN2...
STANDARD
4.4 liters (4.7 US qt, 3.9 lmp qt)
4.6 liters (4.9 US qt, 4.0 lmp qt)
5.2 liters (5.5 US qt, 4.6 lmp qt)
Pro Honda GN4 4-stroke oil or equiva-
lent motor oil
API service classification: SG or Higher
JASO T 903 standard: MA
Viscosity: SAE 10W-30
Above 150 kPa (1.5 kgf/cm
, 22 psi)
2
Above 800 kPa (8.2 kgf/cm
, 116 psi)
2
0.15 (0.006)
0.12 0.22 (0.005 0.009)
0.02 0.09 (0.001 0.004)
LUBRICATION SYSTEM
Unit: mm (in)
SERVICE LIMIT
0.20 (0.008)
0.25 (0.010)
0.11 (0.004)
4-3
3/9/2008 10:42 PM

Advertisement

Table of Contents
loading

Table of Contents