Optional Features And Accessories - 2gig Technologies Go!Control Panel Installation & Programming Manual

Introduction

Optional Features and Accessories

Optional features that can be purchased to enhance the system include:
• 2GIG GSM (Cellular) Radio Module. An on‐board digital communicators reports alarms and trouble to a Central
Station receiver via the standard telephone network and a two (2)‐way voice communication with the Central
Station. It also supports OTA updates and remote control of the system using telephone or a Web‐enabled device
through the Internet.
• 2GIG 900 MHz Transceiver Module. it sends and receives signals with wireless touch screen keypads and image
sensors. Touch screen keypads allow remote control of the system through the same graphic interface design as the
2GIG Control Panel. Note that the 2GIG 900 MHz Transceiver Module, touch screen keypad, and image sensor are
only available in some regions.
• 2GIG Wireless Touch Screen Keypad. A wall‐mounted, full‐color, touch screen interface that provides many of the
same easy‐to‐use keypad functions available on the Control Panel. It is designed for indoor use only and gives users
the ability to control lights, thermostats, and door locks, as well as to view the status of every sensor zone. When
the 2GIG 900 MHz Transceiver Module is installed in the Control Panel, the system can be programmed to
communicate with up to four (4) Wireless Touch Screen Keypads.
• 2GIG Go!Control POTS Module. The POTS (Plain Old Telephone Service) module offers the same features and the
cellular module only over a land‐line (instead of cellular), such as two (2)‐way‐voice communication with the remote
monitoring service.
• 2GIG Go!Bridge IP Communicator. The Go!Bridge provides Internet connectivity between the monitoring service's
Central Station and the Go!Control® Panel (requires the 2GIG 900 MHz Transceiver Module and supports automatic
firmware updates, provides interactive security services, and increases supervision using signal‐forwarding to the
Central Station.
• 2GIG Super Switch Takeover Module. The takeover module communicates with the 2GIG Control Panel and is
designed to convert up to eight (8) pre‐wired zones to supervised wireless zones.
• 2GIG Hardwire Conversion Kit. This kit provides installers with an easy way to convert the zones of a pre‐wired
security alarm system to 2GIG wireless zones. The kit includes one (1) Super Switch Takeover Module (Wireless
Takeover of an Alarm System, US Patent No. 8,638,218). You can also install two (2) additional modules, which
provides installers with the capability to convert up to 24 pre‐wired security zones to wireless zones.
Copyright © 2014 Linear LLC 7