2gig Technologies Go!Control Panel Installation & Programming Manual page 37

Programming Question Table
Q# Question
Q82 Select Z‐Wave Door Locks Feature (0 to 1)
Q83 Select Temperature Display Units (0 to 1)
Q84 Select Services Require Master Code
Q85 Select Master User Access to Z‐Wave Toolbox (0 to 1)
Q86 Select Disable Siren After Two‐Way Audio (0 to 1)
Q87 Select Keyfob/Remote Arming Mode on System Not Ready (0
to 2)
Q88 Select Z‐Wave Siren Mode (0 to 1)
Q89 Select Allow Backlight Always On (Demo Mode)
Q90 Select Energy Feature (0 to 2)
Q91 Select Radio Modem Supplier
Q92 Select Network Device (0 to 1)
Network Device ID (Read‐Only)
Select Port # (1 to 8)
Select Used (0 to 1)
Enter Port Value (0‐65535)
Enter Port Forward IP Address
Q93 Enter Broadband Network Failure Time (1‐255)
Q94 Select Broadband Network Failure Causes Trouble (0 to 1)
Q95 Select Broadband Network Failure Reports (0 to 1)
‡ Indicates the default se ng for ANSI/SIA CP‐01 compliance
* To comply with UL 985:Household Fire Warning System Units, the setting for Q46: Select Trouble Doesn't Sound at Night must
be set to (0) Disabled.
Default
(0) Disabled
(0) Degrees Fahrenheit
(0) Disabled
(0) Disabled
(0) Disabled
(0) Auto‐Bypass with Zone Participation on Restore
(0) Sound for Burglary and Fire/CO
(0) Disabled
(0) Disabled and Hidden
Varies by Supplier
(0) none
0
NOTE: Only appears if (1) Go!Bridge is selected in Q92 Select
Network Device (0 to 1)
(1) Port 1
NOTE: Typically, you will skip this question unless additional
programming is required.
(0) Disabled
NOTE: Typically, you will skip this question unless additional
programming is required.
0
NOTE: Only appears if (1) Enabled is selected in Select Used (0 to
1)
000.000.000.000
NOTE: Only appears if (1) Enabled is selected in Select Used (0 to
1).
NOTE: Typically, you will accept the default IP address value that
appears.
30
(1) Enabled
(1) Enabled
Copyright © 2014 Linear LLC 35