Accessing The System Configuration For System And Sensor Programming; System Configuration Screens - 2gig Technologies Go!Control Panel Installation & Programming Manual

Go!Control Wireless Security System | Installation and Programming Guide
Accessing the System Configuration for
System and Sensor Programming
To access the system configuration screens for
programming sensors into the system:
Disarm the system by pressing Disarm and entering a
1
user code. The default user code is 1111.
2 Access the Installer Toolbox. See Accessing the Installer
Toolbox above.
At the Installer Toolbox screen, press the System
3
Configuration button.
NOTE: The other buttons let you restore the default Control
Panel settings and provides access to a variety of system
tests.
Figure 31 Installer Toolbox Screen
After pressing the System Configuration button, the first
programming question appears. To learn more, see System
Configuration Screens.

SYSTEM CONFIGURATION SCREENS

Use the System Configuration screens to program sensors
into the system. Installers can access the System
Configuration screens as described in Accessing the System
Configuration for System and Sensor Programming.
The System Configuration screens present installers with a
sequential list of programming questions. For a list of all
available programming questions, see "Programming
Question Table" on page 33.
Figure 32 Q1: Select RF Sensor # (01 to 48).
TIP: To simplify programming, questions are arranged so
that commonly used values appear early in the question
sequence.
28 Copyright © 2014 Linear LLC