Operator Functions - Kärcher BR 100 R Service Manual

BR/BD 100/250 R BP / RI
3.3

Operator functions

For operator
Bedienerfunktionen
1. Drive (without cleaning
functions)
2. Wet scrubbing
(with suction)
3. Wet scrubbing
(without suction)
4. Suction (without
scrubbing mode)
5. Polishing (without suc-
tion)
6. Polishing (with suction)
7. Hand cleaning (optional)
Operator settings:
The operator can change
the settings:
– Water volume
– Brush pressure
– Brush speed (FACT)
– Working speed
– Chemicals quantity (optional)
Note:
Apart from the test mode and setup menu,
the service diagnosis will be introduced at a
later date.
Service Manual 08.2007
For service technician
Test-Modus
– Drives
– Lifting motors
– Calibration
1. Functional note on test
mode
The respective test modes can
be selected using the rotary
function info button. After sel-
ection the display begins to flash
after 3 seconds, this means
that the test mode is active and
the tests can be carried out.
2. Display mode
– I-drive
– I-brush
– I-motor
– I-Lifting motor brush head
– I-lifting motor suction beam
– Direction of travel switch
function
– Seat switch function
– Drive pedal function
– Elect. Ball valve (open-clo-
sed)
– Limit position – brush head
(raised - lowered)
– Limit position – suction beam
(raised - lowered)
– Electronics compartment fan
(Off - ON)
– Cleaning module tempera-
ture
– Lifting module temperature
– Accessories module tempe-
rature
Functional note on display
mode
In this mode only data such as
current, voltage, etc. are dis-
played without flashing.
(See Chapter 5.1 / 5.2)
Unit functions
Setup menu
– System parameters
– Driving module parameters
– Cleaning module parameters
– Lifting module parameters
(See Chapter 5.3)
Page 53 / 171