Kärcher BR 100 R Service Manual page 101

BR/BD 100/250 R BP / RI
5.3 Setup menu
5.3.5 Module parameter manufacture settings
PARAMETER-SETUP, sequence and factory settings BR 100/250R(I) - State 2005/05/20
Module Parameter presentation in
display
Lift module (1),
max. speed:
Clone 1: Controls
M2/D-S: 40%
for suction beam
+ scrubber head
max. speed:
Available in:
M2/U-S: 60%
a) Basic unit
b) Basic unit +
side brush
c) Basic unit +
pre-sweeper
Clean module (2),
Clone 2: Control
of the pre-sweeper
Available in:
Basic unit + pre-
sweeper
Lift module (2), max. speed:
Clone 2: Control M2/D-S: 20%
of lift motor pre-
sweeper and side
max. speed:
brush
M2/U-S: 60%
Available in:
a) Basic unit +
side brush
b) Basic unit +
pre-sweeper
Acceleation number #) Start up
1 0.8 m/s
2 1.0 m/s
3 1.2 m/s
1.4 m/s
4
1.6 m/s
5
Service Manual 08.2007
Factory setting min:step:max
40% 15%:5%:70%
60% 15%:5%:70%
20% 15%:5%:70%
60% 15%:5%:70%
##) Braking
2 1.1 m/s 2
2 2
1.3 m/s
2 1.5 m/s 2
2 1.7 m/s 2
2 1.9 m/s 2
Basic settings and service procedures
Notes
Slow nominal speed controller for downward
travel of brush lift motor in the pressure control
phase.
Slow nominal speed of the speed controller during
upward travel brush lift motor in the pressure
control phase.
CANNOT BE ADJUSTED!
Slow nominal speed of the speed controller during
downward travel brush lift motor in the pressure
control phase.
Slow nominal speed of the speed controller during
upward travel brush lift motor in the pressure
control phase.
Standard parameter setup menu
Adjustments must be made by service department for
accessory kits or upgrades!
Available for PRE-SWEEPER option
Available for SIDE BRUSH option
**) IMPORTANT: These values must be changed by the produc-
tion when using a faster or slower drive motor. The access and
values will be announced when the first model is built!!
.+) The adjustment limits given are maximum values. They are
mutually interdependent as follows: t_sweep_max = t_suction_min,
and t_suction_min = t_sweep_max. this ensures that the intake
fan always runs at least as long as the sweeper. Example: Setting:
t_brush_max = 3s -> Setting t_suction_min = 3s. Setting
t_suction_max = 2s -> setting of t_sweep_max = 2s.
Order Service
Development
access
access
1 X
2 X
1 X
2 X
Page 101 / 171